Ultra high output cells are now shipping from the innovative company, Punch HHO.  These cells are touted as the most efficient cells made and are constructed with flat stainless steel plates instead of thin wires.  Additionally, they use a low voltage design to minimize the amount of excess heat and steam that could harm the vehicle’s engine. The electrolyzer cells are produced in three models discussed below:

Punch 1.0 Cell - $299
Punch HHO 1.0 Cell
The Punch 1.0 Cell is capable of over 1 Liter per Minute constant output of HHO gas. Every unit is leak tested and LPM tested before it gets shipped to the customer.  Every connection is sealed to assure no future leakage.  There are no wire connections inside the cell, the stainless streel thread as seen on the top runs all the way to the bottom of the cell to make the connection under the water.  This creates a spark free design that is perfect!

Specifications of the Punch 1.0:
  • 4 316-Stainless Steel Plates (each plate is 6″ long x 4″ wide)
  • Height - 10 inches
  • Width - 4 inches
  • Hydroxy gas prodcution is 1.2 liters per minute at 20 amps

Punch 2.0 Cell - $649
Punch HHO 2.0 Cell
The Punch 2.0 Cell is capable of over 2.5 Liter per Minute constant output of HHO gas. The Punch 2.0 comes in a high quality, heavy duty stainless steel container. The electrodes are stainless steel and run from the top to the bottom of the unit. The connections are under water reducing the chances of sparks! The Punch 2.0 is built to last!

Specifications of the Punch 2.0:
  • 5 316-Stainless Steel Plates (each plate is 9″ long x 4″ wide)
  • Height - 10 inches
  • Width - 5 inches
  • Hydroxy gas prodcution is 2.5 liters per minute at 40 amps

Punch 2.0 Big Punch - $749
Punch 2.0 Big Punch - HHO electrolyzer
The Punch 2.0 Big Punch! It is capable of producing over 3 liters per minute of constant output. The Big Punch is 5″x20″, but is perfect for those of you that own larger trucks, especially big rigs! The Big Punch holds 2 gallons of distilled water, which will last you 30 to 40 hours of constant driving. All connections are at the bottom of the unit for the spark free design.

Specifications of the Punch 2.0 Big Punch:
  • 5 316-Stainless Steel Plates
  • Height - 20 inches
  • Width - 5 inches
  • Hydroxy (HHO) gas prodcution is over 3 liters per minute at 40 amps
These electrolzer cells are the heart of any HHO setup. These cells use the process of electrolysis to change water into hydroxy gas. (hydrogen and oxygen gas) It consists of electrodes that produce hydroxy gas when submerged in water made conductive with electrolyte, such as potassium hydroxide. Electrical current from the vehicle’s alternator / battery is then applied. A substancial amount of hydroxy gas must be produced by an electrolyzer to make the combustion process more efficient. The standard of gas production is measured in liters per minute. (LPM) 1 LPM is considered baseline for a functional supplemental HHO cell. The hydroxy gas output of the electrolyzer is routed to the vehicle’s air intake and vacuum intake manifold. The smaller molecules of the hydroxy gas strike the larger pre-heated gasoline molecules, breaking down the covalent bonds even further and atomizing the gasoline, while adding a combustable catalyst.
Purchase the Punch HHO Cells Here

Share and Enjoy: These icons link to social bookmarking sites where readers can share and discover new web pages.
  • bodytext
  • del.icio.us
  • Mixx
  • Google
  • Reddit
  • StumbleUpon